System One Centrifugal Pumps
The Heavy Duty Pump with solid shaft (no sleeve) conquers vibration and greatly extends seal, bearing and shaft life. It resists the forces of destructive vibration far better than any other general process pump, reducing costly shutdowns. Its oversized angular contact thrust bearings are standard for high thrust capability and eliminate any axial movement of the shaft. With minimal bearing overhang and the lowest L3/D4 stiffness ratio in the industry provides superior resistance to deflection. Product Ranges: Frame S | Frame A | Frame M | LD-17 | Vortex

Rotary Sliding Vane Pumps
These pumps have a number of vanes that are free to slide into or out of slots in the pump rotor. When the pump driver turns the rotor, centrifugal force, push rods, and/or pressurized fluid causes the vanes to move outward in their slots and bear against the inner bore of the pump casing forming pumping chambers. As the rotor revolves, fluid flows into the area between the vanes (pumping cambers) when they pass the suction port. This fluid is transported around the pump casing until the discharge port is reached. At this point the fluid is squeezed out into the discharge piping.

End Suction Pumps: ETAN | CER | CE | CA Series | CPEN | CSA

Horizontal Split Case Double Suction Pumps:  CDM

Multistage Pumps: MMO | MMK/MML | MHD | MHG/MHB

Vertical Pumps: SPV | CSTV | MMTV | IS – ISV | LF

Submersible Pumps: SSC | SWO | SMIV | SMSV | TG DR | TG DG | TG AP | CNS Series

Horizontal Overhung Foot Mounted (OH-1) : design to meet the API610 standard, ANSI or ISO standard, built to transfer mud, heavy duty liquid, abrasive & corrosive.

Horizontal Overhung Centerline Mounted (OH-2) : design to meet the API610 standard, ANSI or ISO standard, built to transfer heavy duty liquid, crude oil, many hydrocarbon with high temperature & etc.

Multistage High Pressure Slurry Pumps : design to transport pipeline slurries or viscous liquids, mine dewatering, crude oill, coal transfer & etc.

Vertical In-Line Pump (OH-3) : design to meet the API610 standard, ANSI or ISO standard, design for limited space and used to transfer many liquid.

Vertical Suspended Pumps (VS-4 & VS-5) : design to meet the API610 standard, ANSI or ISO standard, Application for oil and gas, industrial process, sump drainage, corrosive liquid, polution control, molten salt & sulfur.